SMR Gearbox Set up

SMR Gearbox Installation
Satisfactory effectiveness is determined by good installation. lubrication and servicing. consequently it is crucial that the instructions within the installation and upkeep leaflet. provided with just about every gearbox. are followed carefully. a few of the crucial elements of belt and torque-arm set up are listed under.
1. Install pulley on gearbox input shaft as near to the reducer feasible, and mount reducer on driven shaft as near to bearing as useful. failure to perform this will cause excess loads in the input shaft bearings and output bearings and could cause their premature failure.
two. Install motor and wedge belt drive with the belt pull at approximately 90° for the center line concerning driven and input shafts. this will likely permit tensioning of the wedge belt drive with the torque arm which should really preferably be in tension. if output hub runs anti-clockwise. torque arm must be positioned the best.
3. lnstall torque-arm fulcrum on the rigid assistance so that the torque-arm will be at roughly proper angles to the center line through the driven shaft as well as torque arm situation bolt. ensure there is certainly ample consider up from the turnbuckle for belt tension adjustment.
Retain close.
Bell drive could be located in any convenient postion. should the torque arm is always to be utilized to tighten the belts, the drive really should be at about tight angle for the line amongst the input and output shafts.
Bell drive can be positioned to your correct if desired.
If output hub rotates clock-wise. place belt drive and torque arm in opposite route to that proven within the illustration.
Torque arm and belt get up.
Torque arm could possibly be mounted to your proper if wanted.